Zte ZXR10 GER User Manual

Chapter 6 Interface Configuration
Confidential and Proprietary Information of ZTE CORPORATION 111
Command
Format
Command
Mode
Command Function
source config interface clock extraction
Result: This configures the router interface clock extraction.
4. To set the threshold parameter, use threshold command in
interface configuration mode, as shown in
Table 126.
TABLE 126 THRESHOLD COMMAND
Command
Format
Command
Mode
Command Function
threshold
Interface
config
This sets the threshold
parameter
5. To set the frame type of cpos3, use sdh command in
interface configuration mode, as shown in
Table 127.
TABLE 127 FRAME TYPE
Command
Format
Command
Mode
Command Function
sdh
Interface
config
This sets the frame type of
cpos3 into sdh
sonet.
Interface
config
This sets the frame type of
cpos3 into sonet
END OF STEPS
Refer to below procedure for configuring aug.
Aug-3 Mapping
Refer to below procedure for configuring CPOS on ZTE ZXR10
GER router.
Router Command Line Interface has been accessed.
1. To set the framing format of T1 channel, use tug-2<Vtg
number> t1< T1 number > framing command in interface
configuration mode, as shown in
Table 128.
TABLE 128 T1 CHANNLE FRAME
Command
Format
Command
Mode
Command Function
tug-2<Vtg
number>
t1< T1
number >
framing
Interface
config
This sets the framing format of
T1 channel
Result: This sets the framing format of T1 channel.
Follow Up
Action
Purpose
Prerequisite
Steps

Zte ZXR10 GER Specifications

General

Brand	Zte
Model	ZXR10 GER
Category	Network Router
Language	English