ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
218 Confidential and Proprietary Information of ZTE CORPORATION
[metric-type <type-value>] parameter defines external <Set
IS-IS external metric type> internal <Set IS-IS internal
metric type >.
Result: This configures default route information in IS-IS
routing table.
5. To summarize some entries in IS-IS routing table, use
command summary-address <ip-address> <net-mask>
<value> [level-1|level-1-2|level-2] in IS-IS config mode
as shown in
Table 269.
TABLE 269 SUMMARY-ADDRESS COMMAND
Command Format
Command
Mode
Command Function
summary-address
<ip-address> <net-
mask> <value>
[level-1|level-1-
2|level-2]
IS-IS
config
This defines an address
summary of IS-IS
This command generates a summary that advertise without
the need of detailed routing entries.
Metric value ranges from <0-4261412864>. The least
metric value among the aggregated routing entries
regard as the metric value of the summary route.
E
ND OF STEPS
For More information about IS-IS configuration please follow the
below procedures.
IS-IS Interface Parameters
This below procedure delivers the information about IS-IS
interface configuration parameters.
îš„ Router Command Line Interface has been accessed.
îš„ IS-IS is running in a network.
1. Use command isis circuit-type {level-1|level-1-2|level-
2-only} in IS-IS interface config mode for defining operation
type of an IS-IS interface as shown in
Table 270.
TABLE 270 INTERFACE-LEVEL COMMAND
Command Format
Command
Mode
Command Function
isis circuit-type
{level-1|level-1-
2|level-2-only}
IS-IS
interface
config
This defines the type of
adjacency on an the
interface
Related
Information
Purpose
Prerequisites
Steps
To Next Page
Loading...
Need help?
General
