Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
216 Confidential and Proprietary Information of ZTE CORPORATION
Configuration of R2:
ZXR10_R2(config)#router isis
ZXR10_R2(config-router)#area 01
ZXR10_R2(config-router)#system-id 00D0.D0C7.5460
ZXR10_R2(config-router)#exit
ZXR10_R2(config)#interface fei_1/4
ZXR10_R2(config-if)#ip address 192.168.2.2 255.255.255.0
ZXR10_R2(config-if)#ip router isis
ZXR10_R2(config)#interface fei_1/3
ZXR10_R2(config-if)#ip address 192.168.6.1 255.255.255.0
ZXR10_R2(config-if)#ip router isis
For More information about IS-IS configuration please follow the
below procedures.
Configuring Global IS-IS Parameters
If all routers running on network are ZTE ZXR10 GER, just use
default parameters in IS-IS configuration. However, upon
interconnection with routers of other manufacturers, related
interface parameters and timers need adjustment so that IS-IS
protocol can run more efficiently on network.
IS-IS parameter configuration in IS-IS involves the IS-IS
configuration of global parameters and interface parameters.
Below procedure delivers the information about configuration of
global IS-IS parameters.
 Router Command Line Interface has been accessed.
 IS-IS is running in a network.
1. To define the operation type of router, use command
is-type {level-1|level-1- 2|level-2-only} in IS-IS config
mode as shown in
Table 265.
TABLE 265 IS-TYPE COMMAND
Command Format
Command
Mode
Command Function
is-type
{level-1|level-1-
2|level-2-only}
IS-IS
config
This defines the permitted
IS-IS level
Result: This configures permitted IS-IS level for router.
2. To define PSNP (Serial Number PDU) for point to point
networks, use command isis psnp-interval <num> [level-
1|level-2] in IS-IS interface config mode as shown in
Table
266.
Related
Information
Overview
Purpose
Prerequisite
Steps

Zte ZXR10 GER Specifications

General

Brand	Zte
Model	ZXR10 GER
Category	Network Router
Language	English