Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
150 Confidential and Proprietary Information of ZTE CORPORATION
Result: This enables the BCP Bridge.
Note: ppp bcp enable and ip forwarding-mode attributes are
provided only in the POS real interface. These two attributes
of the POS VLAN sub interface are the same as those of its
parent interface. In addition, the POS VLAN sub interface can
only be used for bridge and will be inactived if its parent
interface does not enable the BCP.
E
ND OF STEPS
Example:
As shown in
Figure 78, R1 is connected with R2 through the
POS3 interface. R2 is connected with R3 through the 100M
interface. In the networking, R2 must be a transparent
transmission device. Througth BCP Encapsulation and Vlan-
Switch configurate, POS Vlan interface can communice to the
ethernet interface of R3 directly, and actived as a pair of
ethernet interfaces in a network.
FIGURE 78 POS BRIDGE CONFIGURATION EXAMPLE
R1 R2
pos3_1/1.10
pos3_1/1
192.168.1.1/30
R3
fei_1/1.100
fei_1/1.100
192.168.1.2/30
R1 configuration:
ZXR10_R1(config)#interface pos3_1/1
ZXR10_R1(config-if)#ppp bcp enable
ZXR10_R1(config-if)#exit
ZXR10_R1(config)#interface pos3_1/1.10
ZXR10_R1(config-subif)#encapsulation dot1Q 10
ZXR10_R1(config-subif)#ip address 192.168.1.1
255.255.255.252
R2 configuration:
ZXR10_R2(config)#interface pos3_1/1
ZXR10_R2(config-if)#ppp bcp enable
ZXR10_R2(config-if)#ip forwarding-mode mix
ZXR10_R2(config-if)#exit
ZXR10_R2(config)#interface fei_1/1
ZXR10_R2(config-if)#ip forwarding-mode mix
ZXR10_R2(config-if)#exit
ZXR10_R2(config)#vlan-forwarding ingress pos3_1/1 10 egress
fei_1/1 10 0
R3 configuration:
ZXR10_R3(config)#interface fei_1/1.100
ZXR10_R3(config-subif)#encapsulation dot1Q 100
ZXR10_R3(config-subif)#ip address 192.168.1.2
255.255.255.252

Zte ZXR10 GER Specifications

General

Brand	Zte
Model	ZXR10 GER
Category	Network Router
Language	English