Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
116 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 141 E1 CHANNLE CLOCK SOURCE
Command
Format
Command
Mode
Command Function
vtg<Vtg
number>
e1< E1
number >
clock
source
Interface
config
This sets the clock source of E1
channel
Result: This sets the clock source of E1 channel.
5. To configure the network address of the CPOS interface, use
ip address command in interface configuration mode, as
shown in
Table 142.
TABLE 142 IP ADDRESS COMMAND
Command
Format
Command
Mode
Command Function
ip address
Interface
configuration
This configures the network
address of the CPOS interface
Result: This configures the network address of the CPOS
interface.
6. To configure crc mode, use ip address command in
interface configuration mode, as shown in
Table 143.
TABLE 143 IP ADDRESS COMMAND
Command
Format
Command
Mode
Command Function
ip address
Interface
config
This configures the crc mode
Result: This configures the crc mode.
E
ND OF STEPS
Example:
As shown in
Figure 69, CP3 of a ZXR10 GER router is
interconnected with that of a remote ZXR10 GER router. It
adopts channelized configuration, 1-24 timeslots, layer-2 WAN
encapsulation protocol PPP, crc16 frame format and internal
clock mode.
FIGURE 69 EXAMPLE OF CHANNELIZED CPOS CONFIGURATION
ZXR10 ZXR10
cpos3_1/1.1/1/1:1
192.168.1.1/30
192.168.1.2/30
cpos3_1/1.1/1/1:1

Zte ZXR10 GER Specifications

General

Brand	Zte
Model	ZXR10 GER
Category	Network Router
Language	English