Zte ZXR10 GER User Manual

Chapter 8 Smart Group Configuration
Confidential and Proprietary Information of ZTE CORPORATION 129
ZXR10 (config-if)#exit
ZXR10 (config)#interface fei_2/3
ZXR10 (config-if)#smartgroup 1 mode active
ZXR10 (config-if)#exit
ZXR10(config)#interface smartgroup1
ZXR10 (config-if)#smartgroup load-balance per-
packet
ZXR10 (config-if)#exit
ZXR10 (config)#interface fei_1/1
ZXR10 (config-
i
f)#ip address 192.19.1.1
255.255.255.0
ZXR10 (config-if)#exit
ZXR10 (config)#ip route 192.18.1.0 255.255.255.0
10.10.10.1
SMARTGROUP Maintenance and
Diagnosis
Refer to below procedure for configuring smartgroup
maintenance and diagnosis on ZTE ZXR10 GER router.
Router Command Line Interface has been accessed.
1. To display the configuration information of the smartgroup
interface, use show running-config command in interface
configuration mode, as shown in
Table 154.
TABLE 154 SHOW RUNNING CONFIG COMMAND
Command
Format
Command
Mode
Command Function
show
running-
config
Interface
config
This displays the configuration
information of the smartgroup
Result: This displays the configuration information of the
smartgroup.
2. Display the relevant information of smartgroup group
members; use show lacp command in interface
configuration mode, as shown in
Table 155.
TABLE 155 SHOW LACP COMMAND
Command
Format
Command
Mode
Command Function
show lacp
Interface
config
This displays the relevant
information of smartgroup
group members
Purpose
Prerequisite
Steps

Zte ZXR10 GER Specifications

General

Brand	Zte
Model	ZXR10 GER
Category	Network Router
Language	English