Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
306 Confidential and Proprietary Information of ZTE CORPORATION
pseudowire technologies are available in all major vendor
products:
 AToM for MPLS networks
 L2TPv3 for native IP networks
Both AToM and L2TPv3 support the transport of Frame Relay,
ATM, HDLC, and Ethernet traffic over an IP or MPLS core.
VPWS is generating interest among service providers that wish
to migrate existing Layer 2 networks to their packet MPLS or IP
network (Figure 4), or for service providers that wish to use the
packet infrastructure to extend Layer 2 service offerings in new
markets. VPWS provides a common framework to encapsulate
and transport supported Layer 2 traffic types over an MPLS
network core. Service providers can use a single MPLS network
infrastructure to offer connectivity for supported Layer 2 traffic
and for IP traffic in Layer 3 VPNs.
Configuring VPWS
VPWS (Virtual Private Wire Service) technology was the first to
be introduced to deal with transport of Layer 2 Ethernet traffic
over an IP/MPLS backbone.
This below procedure describes how to do VPWS configuration
on ZTE ZXR10 GER.
Router Command Line Interface has been accessed.
For the configuration of VPWS, perform the following steps:
1. To configure LDP neighbor, use the following command, as
shown in
Table 347.
TABLE 347 MPLS LDP COMMAND
Command
Format
Command
Mode
Command Function
mpls ldp
target-
session
neighbor-
id
Global This configures LDP neighbor
Result: This configures LDP neighbor.
2. To enable the VPWS in interface, use the following command,
as shown in
Table 348.
IP Network
Background
Purpose
Prerequisite
Steps

Zte ZXR10 GER Specifications

General

Brand	Zte
Model	ZXR10 GER
Category	Network Router
Language	English