Zte ZXR10 GER User Manual

Chapter 6 Interface Configuration
Confidential and Proprietary Information of ZTE CORPORATION 115
1. To enter into the vt-2 configuration mode, use vt-2 1
command in global configuration mode, as shown in
Table
138.
TABLE 138 VT-2.1 COMMAND
Command
Format
Command
Mode
Command Function
vt-2 1 global config
This enables to enter into the
vt-2 configuration mode
Result: This enables to enter into the vt-2 configuration
mode.
2. To set the framing format of E1 channel in VTG, use vtg<Vtg
number > e1< E1 number > framing command in interface
configuration mode, as shown in
Table 139.
TABLE 139 E1 CHANNLE FRAME FORMAT
Command
Format
Command
Mode
Command Function
vtg<Vtg
number >
e1< E1
number >
framing
Interface
config
This sets the framing format of
E1 channel in VTG
Result: This sets the framing format of E1 channel in VTG.
3. To create a CPOS interface in the E1 encapsulation format,
use vtg<Vtg number> e1< E1 number > channel-group 1
timeslots <1-31> command in interface configuration mode,
as shown in
Table 140.
TABLE 140 VTG CHANNEL GROUP
Command
Format
Command
Mode
Command Function
vtg<Vtg
number>
e1< E1
number >
channel-
group 1
timeslots
<1-31>
Interface
config
This creates a CPOS interface in
the E1 encapsulation format
Result: This creates a CPOS interface in the E1
encapsulation format.
4. To set the clock source of E1 channel, use vtg<Vtg number>
e1< E1 number > clock source command in interface
configuration mode, as shown in
Table 141.
Steps

Zte ZXR10 GER Specifications

General

Series	ZXR10
Product Type	Network Router
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Relative Humidity	5% to 95%, non-condensing