Horizontally
You can install the drive horizontally with screws (only back mounting, four holes).
For the installation instructions, see section With screws on page 25.
Note: For the required free space, see the following figure.
WARNING! Horizontal mounting is permitted only for frame sizes R1 and R2
because they include a cooling fan. Position the drive so that the connectors at the
bottom of the drive are situated to the right and the fan to the left as shown in the
following figure. Do not install frame size R0 horizontally!
25
cm
75 cm 75 cm
25
cm
To Next Page
Loading...
Need help?
General
