Operation
You can operate the control panel with the help of menus and keys. You can select
an option, for example, an operation mode or a parameter, by scrolling the and
arrow keys until the option is visible on the display and then pressing the
key.
With the key, you can return to the previous operation level without saving the
made changes.
The ACS150 includes an integrated potentiometer located at the front of the drive. It
is used for setting the frequency reference.
The integrated control panel has six panel modes: Output mode, Reference mode,
Parameter modes (Short parameter and Long parameter modes), Changed
parameters mode and Fault mode. The operation in the first five modes is described
in this chapter. When a fault or alarm occurs, the panel goes automatically to the
Fault mode showing the fault or alarm code. You can reset the fault or alarm in the
Output or Fault mode (see chapter Fault tracing on page 127).
When the power is switched on, the panel is in the Output mode, where you can
start, stop, change the direction, switch between local and remote control,
monitor
up
to three actual values (one at a time) and set the frequency reference. To perform
other tasks, go first to the Main menu and select the appropriate mode. The figure
below shows how to move between the modes.
LOC
49
.
1
Hz
LOC
Main menu
rEF
OUTPUT FWD
MENU FWD
Output mode (p. 63)
Reference mode (p. 64)
The panel goes automatically
to the Fault mode.
FAULT
F0007
LOC
LOC
PAr
S
MENU
FWD
Short parameter mode (p. 65)
PAr
L
FWD
Fault mode (p. 127)
After reset the panel returns to
the previous display.
LOC
MENU
FWD
Long parameter mode (p. 65)
PArCh
MENU
FWD
Changed parameters mode (p. 65)
To Next Page
Loading...
Need help?
General
