Actual signals and parameters
Parameters in the Long parameter mode
Selects how the drive reacts when incorrect input power and motor cable
connection is detected (that is the input power cable is connected to the
motor connection of the drive).
Note: Disabling wiring fault (ground fault) may void the warranty.
The drive trips on fault OUTP WIRING (code F0035).
Automatic fault reset. Automatic resets are possible only for certain fault
types and when the automatic reset function is activated for that fault type.
Defines the number of automatic fault resets the drive performs within the
time defined by parameter 3102 TRIAL TIME.
If the number of automatic resets exceeds the set number (within the trial
time), the drive prevents additional automatic resets and remains stopped.
The drive must be reset from the control panel or from a source selected by
parameter 1604 FAULT RESET SEL.
Example: Three faults have occurred during the trial time defined by
parameter 3102 TRIAL TIME. Last fault is reset only if the number defined
by parameter 3101 NR OF TRIALS is 3 or more.
Trial time
t x = Automatic reset
X X X
Number of the automatic resets
Defines the time for the automatic fault reset function. See parameter 3101
NR OF TRIALS.
Defines the time that the drive waits after a fault before attempting an
automatic reset. See parameter 3101 NR OF TRIALS. If delay time is set to
zero, the drive resets immediately.
Activates/deactivates the automatic reset for the overcurrent fault.
Automatically resets fault OVERCURRENT (code: F0001) after the delay set
by parameter 3103 DELAY TIME.
Activates/deactivates the automatic reset for the intermediate link
overvoltage fault. Automatically resets fault DC OVERVOLT (code: F0002)
after the delay set by parameter 3103 DELAY TIME.
Activates/deactivates the automatic reset for the intermediate link
undervoltage fault. Automatically resets fault DC UNDERVOLT (code:
F0006) after the delay set by parameter 3103 DELAY TIME.
To Next Page
Loading...
Need help?
General
