Go to the Main menu by pressing if you are in the Output mode,
otherwise by pressing repeatedly until you see MENU at the bottom.
If the drive is in remote control (REM shown on the left), switch to local
control by pressing
LOC
. The display briefly shows “LoC” before switching
REM
to local control.
Note: With group 11 REFERENCE SELECT, you can allow changing of the
remote (external) reference in remote control (REM) for example, using the
integrated potentiometer or keys and .
or until you see “rEF” and then press . Now the display
shows the current reference value with
SET
under the value.
If parameter 1109 LOC REF SOURCE = 0 (POT, default):
• To increase the reference value, rotate the integrated potentiometer
clockwise.
• To decrease the reference value, rotate the integrated potentiometer
counterclockwise.
The new value (potentiometer setting) is shown on the display.
• To increase the reference value, press .
• To decrease the reference value, press .
The new value is shown on the display.
Reference mode
In the Reference mode, you can:
• view and set the frequency reference
• start, stop, change direction and switch between local and remote control.
How to view and set the frequency reference
You can set the local frequency reference with the integrated potentiometer in any
mode when the drive is in local control if parameter 1109 LOC REF SOURCE has
the default value 0 (POT). If parameter 1109 LOC REF SOURCE has been changed
to 1 (KEYPAD), you have to set the local frequency reference in the Reference
mode.
You can view the current local reference in the Reference mode only.
If the panel is not in the Reference mode (“rEF” not visible), press key
If parameter 1109 LOC REF SOURCE = 1 (KEYPAD):
To Next Page
Loading...
Need help?
General
