Power-On and Reset State
Output Configuration
Function
Frequency
Amplitude (into 50 ohms)
Offset
Output Units
Output Termination
Modulation
AM Carrier Waveform
AM Modulating Waveform
AM Depth
FM Carrier Waveform
FM Modulating Waveform
FM Peak Frequency Deviation
Burst Carrier Frequency
Burst Count
Burst Rate
Burst Starting Phase
FSK Carrier Waveform
FSK “Hop” Frequency
FSK Rate
Modulation State
Sweep Start / Stop Frequency
Sweep Time
Sweep Mode
System-Related Operations
Power-Down Recall
Display Mode
Comma Separators
Triggering Operations
Trigger Source
Input/Output Configuration
GPIB Address
Interface
Baud Rate
Parity
Calibration
Calibration State
Power-On/Reset State
Sine wave
1 kHz
100 mV peak-to-peak
0.00 Vdc
Volts peak-to-peak
50 ohms
Power-On/Reset State
1 kHz Sine wave
100 Hz Sine wave
100%
1 kHz Sine wave
10 Hz Sine wave
100 Hz
1 kHz Sine wave
1 cycle
100 Hz
0 degrees
1 kHz Sine wave
100 Hz Sine wave
10 Hz
Off
100 Hz / 1 kHz
1 second
Linear
Power-On/Reset State
Disabled
On
On
Power-On/Reset State
Internal
Power-On/Reset State
10
GPIB (IEEE-488)
9600 baud
None (8 data bits)
Power-On/Reset State
Secured
The parameters marked with a bullet (
) are stored in non-volatile memory.
The factory settings are shown.
NOTE: The power-on
state will be different
if you have enabled
the power-down
recall mode.
See “Power-Down Recall
Mode” on page 109
for more information.
For your convenience,
this table is duplicated
on the rear cover of this
manual and on the
Quick Reference Card.
3
Chapter 3 Features and Functions
Power-On and Reset State
123
To Next Page
Loading...
Need help?
General
