Arbitrary Waveform Errors
The following errors indicate failures that may occur during an
arbitrary waveform download. Refer to “Arbitrary Waveform
Commands,” starting on page 174, for more information.
780
VOLATILE arb waveform has not been loaded
The DATA:COPY command copies the waveform downloaded into
VOLATILE memory to the specified name. You must download the
waveform using the DATA VOLATILE or DATA:DAC VOLATILE command
prior to a copy operation.
781 Not enough memory to store new arb waveform; use
DATA:DELete
Up to four user-defined waveforms can be stored in non-volatile
memory. Use the DATA:DEL command to delete the waveform in
VOLATILE memory or any of the four user-defined waveforms in
non-volatile memory. Use the DATA:CAT? command to list all
waveforms currently stored in volatile and non-volatile memory.
782 Cannot overwrite a built-in arb waveform
You cannot overwrite the names of the five built-in arbitrary waveforms.
The following names are reserved and cannot be used with the DATA:COPY
command:
SINC, NEG_RAMP, EXP_RISE, EXP_FALL, and CARDIAC.
783 Arb waveform name too long
The arb name can contain up to 8 characters (used with DATA:COPY
command). The first character must be a letter (A-Z), but the remaining
characters can be numbers (0-9) or the underscore character (“ _ ”).
Blank spaces are not allowed.
784 Name of source arb waveform for copy must be
VOLATILE
The DATA:COPY command copies the arbitrary waveform downloaded
into
VOLATILE memory to the specified name. The source for the copy
operation is always
“VOLATILE” (you cannot copy from any other name).
Chapter 5 Error Messages
Arbitrary Waveform Errors
240
To Next Page
Loading...
Need help?
General
