To set the parity
You can select the parity for RS-232 operation. The function generator is
configured for
8 data bits with no parity when shipped from the factory.
See also “Parity Selection,” on page 116.
1 Turn on the menu.
A: MOD MENU
2 Move across to the
I/O MENU choice on this level.
E: I/O MENU
3 Move down a level and then across to the
PARITY choice.
4: PARITY
4 Move down to the “
PARAMETER” level to select the parity.
Use the left/right arrow keys to see the parity choices. Choose from one
of the following:
None: 8 Bits, Odd: 7 Bits, or Even: 7 bits. When you
set parity, you are indirectly setting the number of data bits.
NONE: 8 BITS
5 Save the change and turn off the menu.
The parity selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
¿
¿
Enter
<
<
Menu On/Off
Shift
<
<
Chapter 4 Remote Interface Reference
To set the parity
220
To Next Page
Loading...
Need help?
General
