EasyManuals Logo
Home>Agilent Technologies>Inverter>33120A

Agilent Technologies 33120A User Manual

Agilent Technologies 33120A
312 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
4 Move down a level and set the start frequency to 50 Hz.
Notice that the
Swp annunciator flashes, indicating that the displayed
parameter is for the sweep mode. For more information on editing
numbers in the menu, refer to “Menu Example 3” earlier in this chapter.
¾50.00 Hz
5 Save the change and turn off the menu.
The start frequency is now set to 50 Hz.
6 Use recall menu to return to the
START F command.
The “recall menu” key returns you to the
START F command, which was
the last command used before you exited the menu.
1: START F
7 Move across to the
STOP F command.
2: STOP F
8 Move down a level and set the stop frequency to 5 kHz.
¾5.000 KHz
9 Save the change and turn off the menu.
At this point, the function generator outputs a continuous sweep from
50 Hz to 5 kHz.
You can generate one frequency sweep by pressing the “Single” key or
applying a trigger pulse to the rear-panel Ext Trig terminal. For more
information, see “To trigger a burst or sweep” on the next page.
¿
Enter
¿
Enter
Recall Menu
Shift
<
>
Chapter 2 Front-Panel Menu Operation
To output a frequency sweep
50

Table of Contents

Other manuals for Agilent Technologies 33120A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies 33120A and is the answer not in the manual?

Agilent Technologies 33120A Specifications

General IconGeneral
BrandAgilent Technologies
Model33120A
CategoryInverter
LanguageEnglish

Related product manuals