11-7
Troubleshooting
LCD Messages
See the table below when the LCD displays error and status messages.
Message Description Action
ADJUSTING WAITING TO
SCAN
The machine is not ready for
scanning.
Wait until the machine is ready.
AUTO REDIAL This message appears when
the recipient is engaged in
direct sending and the job is
waiting.
Disappears when the
transmission restarts.
CHANGE PAPERSIZE The size of the paper in the
paper cassette or multipurpose
tray is different from that of the
paper specified in <REG. PAPER
SIZE> or <MP TRAY STD SET>
in the <COMMON SETTINGS>
menu.
Load the paper which size is
shown on the lower line of
the LCD display. Or change
the paper size setting.
Then reset the machine by
opening the left cover and
then closing it.
If you are trying to print a
report or list, set the paper
size to <LTR> or <LGL>, then
load paper of the same size.
–
–
CHANGE REG’D SIZE
COMMON SETTINGS
This message appears at the
same time when <LOAD
PAPER> is shown. You may not
print at the current paper size.
Change paper on the paper
cassette or multi-purpose tray.
And you must also change the
size setting in the <COMMON
SETTINGS> menu.
CHECK DOCUMENT A document jam may have
occurred in the ADF.
Remove the jammed
document.
To Next Page
Loading...
Need help?
General