Configuring the Destination for AppleTalk Networks
To print over an AppleTalk network, activate the AppleTalk protocol and configure the destination as follows.
Activating AppleTalk on the printer
Important
• By factory default, the AppleTalk protocol is disabled on the printer.
1. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press â–² or â–¼ to select Interface Setup, and then press the OK button.
4. Press â–² or â–¼ to select AppleTalk, and then press the OK button.
5. Press â–² or â–¼ to select On, and then press the OK button.
6. Press the Menu button.
If any of the settings is changed, a confirmation message is displayed. In this case, press the OK button.
Important
• Be sure to complete step 6. This will activate the values you have entered.
Network Setting
>
Mac OS X Settings
>
iPF750
Configuring the Destination for AppleTalk Networks
9
723
To Next Page
Loading...
Need help?
General