8. Press â–² or â–¼ to select the communication mode, and then press the OK button.
The display reverts to the Ethernet Driver menu.
9. Press â–² or â–¼ to select Ethernet Type, and then press the OK button.
10. Press â–² or â–¼ to select the Ethernet type, and then press the OK button.
The display reverts to the Ethernet Driver menu.
11. Press â–² or â–¼ to select Spanning Tree, and then press the OK button.
12. Press â–² or â–¼ to enable or disable spanning tree support, and then press the OK button.
The display reverts to the Ethernet Driver menu.
13. Press the Menu button.
After the confirmation message is displayed, press the OK button.
The new settings will take effect after the printer restarts.
Email Notification When Printing is Finished or Errors Occur
The printer can notify you of the printer status by email. Even when you are away from the printer, you can know when
printing is finished or if errors occur. Receive notification via email on your mobile phone or at your computer.
Use the imagePROGRAF Status Monitor (Windows) function to set up email recipients and message timing. Besides being
informed of finished print jobs or errors, you can also complete settings for email notification when service is needed or it's
time to replace consumables. For detailed instructions,see "Specifying Printer-Related Information." →P.726
Network Setting
>
Other Settings
>
Email Notification When Printing is Finished or Errors Occur
iPF750
9
728
To Next Page
Loading...
Need help?
General