"Manually rewind the roll all the way and press OK."
Cause Corrective Action
A paper jam occur-
red when advancing
the paper.
1. Rewind paper on the Roll Holder manually, all the way, and then press the OK button.
2. Load the paper.
3. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
→P.579
Paper is crooked.
Cause Corrective Action
Paper loaded crooked was detected when the paper was ad-
vanced.
Follow these steps to reload the roll.
1. Push the Release Lever back.
2. Adjust the right edge of the roll to make it parallel
to the orange Paper Alignment Line.
3. Pull the Release Lever forward.
(See "Loading Rolls in the Printer.") →P.579
If this error recurs after you reload the roll, remove
the Roll Holder from the printer, push the roll firmly
in until it touches the Roll Holder flange, and reload
the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
→P.575
Follow these step to reload a sheet.
1. Push the Release Lever back.
2. Pull out the sheet.
3. Pull the Release Lever forward.
4. Reload the sheet, aligning it with the guide on the
right.
(See "Loading Sheets in the Printer.")
→P.602
Important
• To disable this message (if it is displayed repeatedly despite reloading paper, for example), choose Off or
Loose in the Skew Check Lv. setting of the printer menu. However, this may cause jams and printing prob-
lems because paper may be askew when printed. Also, the Platen may become soiled, which may soil the
back of the next document when it is printed.
Error Message
>
Messages regarding paper
>
Paper is crooked.
iPF750
12
818
To Next Page
Loading...
Need help?
General