Manag-
eRemain-
Roll
Barcodes Printer Operation After the Paper is Fed
On
Not prin-
ted
A menu for selection of the paper type and length is automatically shown on the Display
Screen.
Press â–² or â–¼ to select the type and length of paper loaded, and then press the OK button.
Note
• For details on types of paper to select, see the Paper Reference Guide. (See "Types of Paper.")
→P.620
8. Holding it at the positions indicated, close the Roll Cover.
Note
• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors or
the blade after removing creased edges. (See "Specifying the Cutting Method for Rolls.") →P.644
Changing the Type of Paper
Follow these steps to change the type of paper specified on the printer after you have loaded paper.
If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of config-
uring the media type setting when you load the paper again. The current media type settings before you select On will be
automatically selected at that time. (See "Using the Same Type of Paper Regularly.")
→P.634
Important
• For best printing results, the printer fine-tunes the feed amount for each type of paper. Be sure to select the
type of paper to use correctly before printing.
• Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printed
images may vary depending on the type of paper used. If margins and the size of images are not as you ex-
pected, adjust the paper feed amount.
(See "Adjusting the Feed Amount.") →P.673
Changing the Type of Paper
Note
• After you load a roll, the printer automatically shows a menu for selection of the type of paper on the Display
Screen. Select the type of paper and press the OK button.
If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the roll
length after the type of paper. (See "Specifying the Paper Length.") →P.635
Handling Paper
>
Handling rolls
>
iPF755 Changing the Type of Paper
7
633
To Next Page
Loading...
Need help?
General