Depression on the leading edge is left
Cause Corrective Action
Keeping a roll in the printer for a long
time without printing on it may leave a de-
pression on the leading edge.
When printing quality is most important, we recommend setting Tri-
mEdge Reload to On or Automatic so that the paper edge is automati-
cally cut before printing.
(See "Menu Structure.") →P.704
The size of clear film cannot be detected
Cause Corrective Action
The Platen is soiled with ink or other substances. Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.") →P.811
Roll Paper is Continuously Ejected
Cause Corrective Action
Although sheets are
selected as the paper
source, a roll was ad-
vanced.
After roll ejection stops, follow these steps to reload the roll.
1. Push the Release Lever back.
2. Open the Roll Cover.
3. Using both hands, rotate the Roll Holder toward the back to rewind the roll. At this time,
ensure that both ends of the roll are rewound evenly.
4. Pull the Release Lever forward.
5. Load the roll. At this time, be sure to press the Load button and select Load Roll Paper.
(See "Loading Rolls in the Printer.") →P.630
Troubleshooting
>
Problems Regarding Paper
>
Depression on the leading edge is left iPF755
12
834
To Next Page
Loading...
Need help?
General