Reducing Dust from Cutting Rolls
For media such as Backlit Film that are more likely to generate debris when cut, select CutDustReduct. > On in the Paper
Menu of the Control Panel. This option reduces debris from cutting by printing black lines at the leading and trailing edges
of documents. It may help prevent Printhead damage. You can specify for CutDustReduct. to be activated for particular
types of paper.
Important
• Do not set CutDustReduct. to On for paper that wrinkles easily, such as Plain Paper or lightweight paper.
This may impair cutting and cause paper jams.
• Borderless printing is not available when CutDustReduct. is set to On. To use borderless printing, select
CutDustReduct. > Off.
Set CutDustReduct. to On as follows.
1. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Paper tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Paper Menu is displayed.
3. Press â–² or â–¼ to select Paper Details, and then press the OK button.
4. Press â–² or â–¼ to select the type of paper loaded in the printer, and then press the OK button.
5. Press â–² or â–¼ to select CutDustReduct., and then press the OK button.
6. Press â–² or â–¼ to select On, and then press the OK button.
Handling Paper
>
Handling rolls
>
iPF755 Reducing Dust from Cutting Rolls
7
651
To Next Page
Loading...
Need help?
General