Handling sheets
Loading Sheets in the Printer .......................................................................................................................... 652
Printing From a Desired Starting Point ............................................................................................................ 656
Removing Sheets ............................................................................................................................................ 659
Loading Sheets in the Printer
Follow these steps to load sheets in the printer.
Important
• One sheet of paper can be loaded in the Paper Feed Slot at a time. Do not load more than one sheet at a time.
This may cause paper jams.
• Before feeding paper or printing, make sure the sheet is flat against the Roll Cover. The sheet may jam if it
curls before feeding or printing and the trailing edge drops toward the front.
Note
• Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.
• Paper that is wrinkled or warped may jam. If necessary, straighten the paper and reload it.
• Load the paper straight. Loading paper askew will cause an error.
1. Select sheets as the paper source.
•
If a print job was received
Sheets are automatically selected, and the media type and size specified by the print job are shown on the Dis-
play Screen. Go to the next step.
•
If no print job was received
1. Press the Load button.
2. Press â–² or â–¼ to select Load Cut Sheet, and then press the OK button.
Note
• If any paper has been advanced that will not be used, a message is shown requesting you to remove it.
Press â–² or â–¼ to select "Yes", and then press the OK button. Remove the paper and go to the next
step.
Handling Paper
>
Handling sheets
>
Loading Sheets in the Printer iPF755
7
652
To Next Page
Loading...
Need help?
General