Roll paper cannot be inserted into the paper feed slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot. Remove the jammed paper.
(See "Clearing Jammed Roll Paper.") →P.826
(See "Clearing a Jammed Sheet.") →P.830
The paper source selection is incorrect. Press the Load button and select the paper source.
Cannot load sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
Paper is not cut neatly
Cause Corrective Action
The paper is bent or curled at the cut position. Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut position be-
fore it is cut.
Reload the paper correctly.
You are using paper that cannot be cut with
the Cutter Unit.
Specify Manual in Cutting Mode in the Control Panel menu and use
scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.") →P.644
Cut Speed is not configured correctly in the
Control Panel menu.
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.") →P.704
During cutting, printed documents fall out at
an angle.
In the Control Panel menu, set Cutting Mode to Eject. Hold docu-
ments after printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.") →P.644
Paper is not cut
Cause Corrective Action
In the printer driver, No or Print Cut Guideline is
specified in Auto Cut.
Specify Yes in Auto Cut in the printer driver.
In the Control Panel menu, Cutting Mode is set to
Eject or Manual.
If the Cutting Mode is Eject, press the Cut button to cut the pa-
per.
If the Cutting Mode is Manual, cut rolls with scissors or the
like.
Troubleshooting
>
Problems Regarding Paper
>
iPF755 Roll paper cannot be inserted into the paper feed slot
12
833
To Next Page
Loading...
Need help?
General