Advanced Settings of Receive Mode
You can specify the advanced settings of each receive mode.
This section describes the procedure to specify the advanced settings of the receive mode and the setting
items.
Specify the advanced settings following the procedure below.
1.
Make sure that the machine is turned on.
Confirming that the Power Is On
2.
Press the FAX button.
The Fax standby screen is displayed.
3.
Press the Menu button.
The FAX menu screen is displayed.
4. Use the button to select Receive mode set., then press the OK button.
5.
Use the button to select a receive mode, then press the OK button.
The confirmation screen asking whether to make advanced settings is displayed.
6.
Use the button to select Yes, then press the OK button.
7.
Use the button to select a setting item, then press the OK button.
8. Use the button to specify the setting, then press the OK button.
Depending on the setting items, the related setting items are displayed after you specify the setting of
the advanced settings and press the OK button. Use the button again to specify the setting, then
press the OK button. The LCD returns to the Fax standby screen after you finish specifying all
settings.
Note
The * (asterisk) on the LCD indicates the current setting.
For details on advanced settings of each receive mode, see below.
Advanced setting in TEL priority mode
Advanced setting in Fax only mode
Advanced setting in DRPD
Advanced setting in Network switch
Note
Refer to Receiving Faxes for information on receiving faxes or the procedure for each receive mode.
DRPD is available only in the US and Canada.
Network switch may not be available depending on the country or region of purchase.
Advanced setting in TEL priority mode
You can specify the following setting items.
•
Manual/auto switch
If you select ON, the machine automatically receives faxes after the external device rang a specified
length of time.
You can specify the length of time until automatic reception is started.
•
User-friendly RX
To Next Page
Loading...
Need help?
General
