Cisco ASA 5540 User Manual

1-4
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring a Service Policy Using the Modular Policy Framework
Information About Service Policies
Note Application inspection includes multiple inspection types, and most are mutually exclusive.
For inspections that can be combined, each inspection is considered to be a separate feature.
For example, if a packet matches a class map for connection limits, and also matches a class map for an
application inspection, then both actions are applied.
If a packet matches a class map for HTTP inspection, but also matches another class map that includes
HTTP inspection, then the second class map actions are not applied.
If a packet matches a class map for HTTP inspection, but also matches another class map that includes
FTP inspection, then the second class map actions are not applied because HTTP and FTP inspections
cannpt be combined.
If a packet matches a class map for HTTP inspection, but also matches another class map that includes
IPv6 inspection, then both actions are applied because the IPv6 inspection can be combined with any
other type of inspection.
Order in Which Multiple Feature Actions are Applied
The order in which different types of actions in a policy map are performed is independent of the order
in which the actions appear in the policy map.
Note NetFlow Secure Event Logging filtering and User statistics for Identity Firewall are order-independent.
Actions are performed in the following order:
1. QoS input policing
2. TCP normalization, TCP and UDP connection limits and timeouts, TCP sequence number
randomization, and TCP state bypass.
Note When a the ASA performs a proxy service (such as AAA or CSC) or it modifies the TCP payload
(such as FTP inspection), the TCP normalizer acts in dual mode, where it is applied before and
after the proxy or payload modifying service.
3. ASA CSC
4. Application inspections that can be combined with other inspections:
a. IPv6
b. IP options
c. WAAS
5. Application inspections that cannot be combined with other inspections. See the “Incompatibility of
Certain Feature Actions” section on page 1-5 for more information.
6. ASA IPS
7. ASA CX
8. QoS output policing
9. QoS standard priority queue
10. QoS traffic shaping, hierarchical priority queue

Cisco ASA 5540 Specifications

General

Firewall Throughput	650 Mbps
Maximum Firewall Connections	400, 000
VPN Throughput	225 Mbps
Maximum VPN Peers	5, 000
High Availability	Active/Active, Active/Standby
IPSec VPN Throughput	225 Mbps
Memory	1 GB
IPS Throughput	225 Mbps
Security Contexts	50
Flash Memory	64 MB
Form Factor	1U
Power Supply	Dual
Interfaces	4 x 10/100/1000 Ethernet