1-27
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring SNMP
Monitoring SNMP
SNMP Syslog Messaging
SNMP generates detailed syslog messages that are numbered 212nnn. Syslog messages indicate the
status of SNMP requests, SNMP traps, SNMP channels, and SNMP responses from the ASA or ASASM
to a specified host on a specified interface.
For detailed information about syslog messages, see the syslog messages guide.
Note SNMP polling fails if SNMP syslog messages exceed a high rate (approximately 4000 per second).
SNMP Monitoring
To monitor SNMP, enter one of the following commands:
Examples
The following example shows how to display SNMP server statistics:
hostname(config)# show snmp-server statistics
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Get-bulk PDUs
Command Purpose
show running-config [default] snmp-server
Shows all SNMP server configuration information.
show running-config snmp-server group
Shows SNMP group configuration settings.
show running-config snmp-server host
Shows configuration settings used by SNMP to control
messages and notifications sent to remote hosts.
show running-config snmp-server user
Shows SNMP user-based configuration settings.
show snmp-server engineid
Shows the ID of the SNMP engine configured.
show snmp-server group
Shows the names of configured SNMP groups.
Note If the community string has already been configured,
two extra groups appear by default in the output. This
behavior is normal.
show snmp-server statistics
Shows the configured characteristics of the SNMP server.
To reset all SNMP counters to zero, use the clear
snmp-server statistics command.
show snmp-server user
Shows the configured characteristics of users.
To Next Page
Loading...
Need help?
General
