Cisco ASA 5540 User Manual

1-5
Cisco ASA Series CLI Configuration Guide
Chapter 1 Adding a Standard Access Control List
Feature History for Standard Access Lists
The following example shows how to permit IP traffic through the ASA if conditions are matched:
hostname(config)# access-list 77 standard permit
The following example shows how to specify a destination address:
hostname(config)# access-list 77 standard permit host 10.1.10.123
Feature History for Standard Access Lists
Table 1-2 lists the release history for this feature.
Table 1-2 Feature History for Standard Access Lists
Feature Name Releases Feature Information
Standard access lists 7.0(1) Standard access listsidentify the destination IP addresses of
OSPF routes, which can be used in a route map for OSPF
redistribution.
We introduced the feature and the following command:
access-list standard.

Cisco ASA 5540 Specifications

General

Firewall Throughput	650 Mbps
Maximum Firewall Connections	400, 000
VPN Throughput	225 Mbps
Maximum VPN Peers	5, 000
High Availability	Active/Active, Active/Standby
IPSec VPN Throughput	225 Mbps
Memory	1 GB
IPS Throughput	225 Mbps
Security Contexts	50
Flash Memory	64 MB
Form Factor	1U
Power Supply	Dual
Interfaces	4 x 10/100/1000 Ethernet