Cisco ASA 5540 User Manual

CHAPTER
1-1
Cisco ASA Series CLI Configuration Guide
1
Adding a Standard Access Control List
This chapter describes how to configure a standard access list and includes the following sections:
• Information About Standard Access Lists, page 1-1
• Licensing Requirements for Standard Access Lists, page 1-1
• Guidelines and Limitations, page 1-1
• Default Settings, page 1-2
• Adding Standard Access Lists, page 1-3
• What to Do Next, page 1-4
• Monitoring Access Lists, page 1-4
• Configuration Examples for Standard Access Lists, page 1-4
• Feature History for Standard Access Lists, page 1-5
Information About Standard Access Lists
Standard access lists identify the destination IP addresses of OSPF routes and can be used in a route map
for OSPF redistribution. Standard access lists cannot be applied to interfaces to control traffic.
Licensing Requirements for Standard Access Lists
The following table shows the licensing requirements for this feature:
Guidelines and Limitations
This section includes the guidelines and limitations for this feature:
• Context Mode Guidelines, page 1-2
• Firewall Mode Guidelines, page 1-2
Model License Requirement
All models Base License.

Cisco ASA 5540 Specifications

General

Firewall Throughput	650 Mbps
Maximum Firewall Connections	400, 000
VPN Throughput	225 Mbps
Maximum VPN Peers	5, 000
High Availability	Active/Active, Active/Standby
IPSec VPN Throughput	225 Mbps
Memory	1 GB
IPS Throughput	225 Mbps
Security Contexts	50
Flash Memory	64 MB
Form Factor	1U
Power Supply	Dual
Interfaces	4 x 10/100/1000 Ethernet