Cisco ASA 5540 User Manual

1-17
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring OSPF
Configuring OSPFv3
To log OSPFv2 neighbors going up or down, perform the following steps:
Detailed Steps
Configuring OSPFv3
This section describes how to configure OSPFv3 routing processes and includes the following topics:
• Enabling OSPFv3, page 1-19
• Configuring OSPFv3 Interface Parameters, page 1-20
• Configuring OSPFv3 Router Parameters, page 1-25
• Configuring OSPFv3 Area Parameters, page 1-27
• Configuring OSPFv3 Passive Interfaces, page 1-30
• Configuring OSPFv3 Administrative Distance, page 1-30
• Configuring OSPFv3 Timers, page 1-31
• Defining Static OSPFv3 Neighbors, page 1-34
• Resetting OSPFv3 Default Parameters, page 1-36
• Sending Syslog Messages, page 1-37
• Suppressing Syslog Messages, page 1-37
• Calculating Summary Route Costs, page 1-38
• Generating a Default External Route into an OSPFv3 Routing Domain, page 1-38
• Configuring an IPv6 Summary Prefix, page 1-39
• Redistributing IPv6 Routes, page 1-40
Command Purpose
Step 1
router ospf process_id
Example:
hostname(config)# router ospf 2
Creates an OSPFv2 routing process and enters router
configuration mode for this OSPFv2 process.
The process_id argument is an internally used identifier for this
routing process and can be any positive integer. This ID does not
have to match the ID on any other device; it is for internal use
only. You can use a maximum of two processes.
Step 2
log-adj-changes [detail]
Example:
hostname(config-rtr)# log-adj-changes
[detail]
Configures logging for neighbors going up or down.

Cisco ASA 5540 Specifications

General

Firewall Throughput	650 Mbps
Maximum Firewall Connections	400, 000
VPN Throughput	225 Mbps
Maximum VPN Peers	5, 000
High Availability	Active/Active, Active/Standby
IPSec VPN Throughput	225 Mbps
Memory	1 GB
IPS Throughput	225 Mbps
Security Contexts	50
Flash Memory	64 MB
Form Factor	1U
Power Supply	Dual
Interfaces	4 x 10/100/1000 Ethernet