Cisco ASA 5540 User Manual

1-11
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the ASA CX Module
Configuring the ASA CX Module
What to Do Next
• (Optional) Configure the authentication proxy port. See the “(Optional) Configuring the
Authentication Proxy Port” section on page 1-11.
• Divert traffic to the ASA CX module. See the “Redirecting Traffic to the ASA CX Module” section
on page 1-12.
(Optional) Configuring the Authentication Proxy Port
The default authentication port is 885. To change the authentication proxy port, perform the following
steps. For more information about the authentication proxy, see the “Information About Authentication
Proxy” section on page 1-3.
Note You can also set the port as part of the ASDM startup wizard. See the “Configuring Basic ASA CX
Settings at the ASA CX CLI” section on page 1-8.
Detailed Steps
Command Purpose
cxsc auth-proxy port port
Example:
hostname(config)# cxsc auth-proxy port 5000
Sets the authentication proxy port greater than 1024. The default
is 885.

Cisco ASA 5540 Specifications

General

Firewall Throughput	650 Mbps
Maximum Firewall Connections	400, 000
VPN Throughput	225 Mbps
Maximum VPN Peers	5, 000
High Availability	Active/Active, Active/Standby
IPSec VPN Throughput	225 Mbps
Memory	1 GB
IPS Throughput	225 Mbps
Security Contexts	50
Flash Memory	64 MB
Form Factor	1U
Power Supply	Dual
Interfaces	4 x 10/100/1000 Ethernet