Cisco cBR 8 Configuration Guide

Configuring Weekend Monitoring
This section describes the tasks required to configure weekend monitoring for STM on a Cisco CMTS router.
Prerequisites
You must first configure the weekday monitoring parameters for an enforce-rule before configuring weekend
monitoring. See the Creating and Configuring an Enforce-Rule, on page 125.
Restrictions
•
Up to 40 total enforce-rules across both upstream and downstream configurations are supported.
•
When using SNMP for weekend monitoring, only SNMP GET and GETMANY operations are supported.
Configuring Different Legacy Monitoring Conditions for Weekends
Use the following procedure if you want to establish different legacy monitoring conditions for subscribers
for either upstream or downstream traffic on weekend days.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode. Enter your
password if prompted.
enable
Example:
Router> enable
Step 1
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Accesses the enforce-rule with the specified
name and enters enforce-rule configuration
mode.
cable qos enforce-rule name
Example:
Router(config)# cable qos enforce-rule
test
Step 3
Specifies the time period and sample rate used
for monitoring subscribers on weekends.
weekend duration minutes avg-rate rate
sample-interval minutes {downstream |
upstream} [penalty minutes] [enforce]
Step 4
Example:
Router(enforce-rule)# weekend duration
15 avg-rate 500 sample-interval 10
penalty 120 downstream enforce
Cisco cBR Series Converged Broadband Routers Quality of Services Configuration Guide for Cisco IOS XE
Fuji 16.7.x
130
Subscriber Traffic Management
Configuring Weekend Monitoring

Cisco cBR 8 Specifications

General

Brand	Cisco
Model	cBR 8
Category	Network Router
Language	English