EasyManuals Logo
Home>Cisco>Switch>MDS 9700 Series

Cisco MDS 9700 Series User Manual

Cisco MDS 9700 Series
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
Nondisruptive Migration for Supervisor Modules
This topic describes the steps that are required to migrate both Supervisor-1 Modules (DS-X97-SF1-K9) to
Supervisor-4 Modules (DS-X97-SF4-K9) for the Cisco MDS Multilayer Director 9706 or 9710, and
Supervisor-1E Modules (DS-X97-SF1E-K9) to Supervisor-4 Modules (DS-X97-SF4-K9) for the Cisco MDS
9718 Multilayer Director.
This topic includes the following sections:
Nondisruptive Migration for Dual Supervisor Modules
Before you install, operate, or service the system, read the Regulatory Compliance and Safety Information
for the Cisco MDS 9000 Family for important safety information.
Note
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol indicates danger. You are in a situation that could cause physical injury. Before you
work on any equipment, be aware of the hazards that are involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for an installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 1022
Warning
Ensure that there is no loose debris (such as paper, ties, dust) around the back of the chassis when the crossbar
switching modules are being removed. When the crossbar switching modules are pulled, the vacuum created
can be strong enough to pull the loose debris into the chassis.
Warning
Cisco MDS 9700 Series Switches Hardware Installation Guide
117
Installing, Removing, and Verifying Field Replaceable Units
Nondisruptive Migration for Supervisor Modules

Table of Contents

Other manuals for Cisco MDS 9700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9700 Series and is the answer not in the manual?

Cisco MDS 9700 Series Specifications

General IconGeneral
BrandCisco
ModelMDS 9700 Series
CategorySwitch
LanguageEnglish

Related product manuals