Cisco RV180 Administrator's Manual

Introduction
Using the Getting Started Page
Cisco RV180/RV180W Administration Guide 17
1
Using the Getting Started Page
The Getting Started page displays the most common Cisco RV180/RV180W
configuration tasks. Use the links on this page to jump to the relevant configuration
page.
By default, this page appears when you start the Device Manager. However, you
can change this behavior by checking Don’t show this on start up at the bottom
of the page.
Initial Settings
Quick Access
Run Setup Wizard Click this link to launch the Setup Wizard.
Configure WAN
(Internet) Settings
Click this link to open the Internet Setup page.
See Configuring the IPv4 WAN (Internet),
page 25.
Configure LAN
(Local Network)
Settings
Click this link to open the LAN Configuration page.
See Configuring IPv4 LAN (Local Network)
Settings, page 32.
Configure Wireless
Settings (RV180W only)
Click this link to open the Basic Settings page.
See Configuring Basic Wireless Settings,
page 63.
Add VPN Clients See Configuring VPN Users, page 119.
Upgrade Device
Firmware
Click this link to open the
Firmware Upgrade page.
See Upgrading Firmware, page 152.
Backup/Restore
Settings
Click this link to open the
Backup and Restore page.
See Backing Up and Restoring the System,
page 148

Cisco RV180 Specifications

General

Brand	Cisco
Model	RV180
Category	Network Router
Language	English