Port Management
Static and Dynamic LAG Workflow
Cisco Small Business 300 Series Managed Switch Administration Guide 92
9
Static and Dynamic LAG Workflow
To configure a static LAG, perform the following actions:
1. Configure the selected LAG as a static LAG by disabling LACP on the LAG.
Assign up to eight active member ports to the static LAG by selecting and
moving the ports from the Port List to the LAG Members list by using the
LAG
Management Page
.
2. Configure the LAG speed and flow control by using the
LAG Settings Page
.
To configure a dynamic LAG, perform the following actions:
1. Configure the selected LAG as a dynamic LAG by enabling LACP on the LAG.
Assign up to 16 candidates ports to the dynamic LAG by selecting and moving
the ports from the Port List to the LAG Members List by using the
LAG
Management Page
.
2. Configure the LAG speed and flow control by using the
LAG Settings Page
.
3. Configure the LACP parameters of the ports in the LAG by using the
LACP Page
.
Defining LAG Management
The LAG Management Page displays the global and per LAG settings. The page
also enables you to configure the global setting and to select and edit the desired
LAG on the Edit LAG Membership Page.
STEP 1 To configure LAG management, click Port Management > Link Aggregation >
LAG Management. The
LAG Management Page
opens.
STEP 2 Select one of the following Load Balance Algorithms:
• MAC Address—Perform loading balancing by source and destination MAC
addresses on all packets.
• IP/MAC Address—Perform load balancing by the source and destination IP
addresses on IP packets, and by the source and destination MAC addresses
on non-IP packets
STEP 3 Click Apply. The Load Balance Algorithm is defined, and the switch is updated.
To Next Page
Loading...
Need help?
General
