Configuring Quality of Service
Configuring QoS
Cisco Small Business 300 Series Managed Switch Administration Guide 249
18
7. Enter bandwidth and rate limits in the following pages:
a. Set egress shaping per queue by using the Egress Shaping Per Queue
Page.
b. Set ingress rate limit and egress shaping rate per port by using the
Bandwidth Page.
c. Set VLAN ingress rate limit by using the VLAN Ingress Rate Limit Page
8. Configure the selected mode by performing one of the following:
a. Configure Basic mode, as described in Workflow to Configure Basic QoS
Mode
b. Configure Advanced mode, as described in Workflow to Configure
Advanced QoS Mode.
Configuring QoS
Displaying QoS Properties
Displaying QoS Properties
The
QoS Properties Page
contains fields for setting the QoS mode for the system
(Basic, Advanced, or Disabled, as described in the “QoS Modes” section). In
addition, the default CoS priority for each interface can be defined.
To s e l e c t t h e Q o S m o d e :
STEP 1 Click Quality of Service > General > QoS Properties. The QoS Properties Page
opens.
STEP 2 Select the QoS Mode (Disable, Basic, or Advanced) that will be active on the
switch and click Apply.
To Next Page
Loading...
Need help?
General
