Viewing Statistics
Viewing TCAM Utilization
Cisco Small Business 300 Series Managed Switch Administration Guide 14
2
• EAP Response Frames Received—EAP Response frames received by the
port (other than Resp/ID frames).
• EAP Request/ID Frames Transmitted—EAP Req/ID frames transmitted by
the port.
• EAP Request Frames Transmitted—EAP Request frames transmitted by
the port.
• Invalid EAPOL Frames Received—Unrecognized EAPOL frames received
on this port.
• EAP Length Error Frames Received—EAPOL frames with an invalid Packet
Body Length received on this port.
• Last EAPOL Frame Version—Protocol version number attached to the most
recently received EAPOL frame.
• Last EAPOL Frame Source—Source MAC address attached to the most
recently received EAPOL frame.
Viewing TCAM Utilization
The switch architecture uses a TCAM (Ternary Content Addressable Memory) to
support an extensive data search in a short period of time.
TCAM holds the rules produced by other processes, such as ACLs (Access
Control Lists) or QoS. The maximum number of TCAM rules that can be allocated
by all processes is 512.
Some processes allocate rules upon their initiation. Additionally, processes that
initialize during system boot use some of their rules during the startup process.
To view TCAM utilization, click Status and Statistics > TCAM Utilization. The
TCAM Utilization Page
opens, displaying the percentage of TCAM utilization in
the system.
This page displays TCAM Utilization, the percentage of TCAM resources used.
The TCAM Rules Per Process table lists all processes that can allocate TCAM
rules. Each process has its specific allocation policy.
To Next Page
Loading...
Need help?
General
