309
CLUTCH
GEARBOX
DRIVESHAFTS
RECOMMENDATIONS - PRECAUTIONS (AL4 AUTOMATIC GEARBOX)
Engines: NFU - RFJ
B2CP3X6D
Checking the oil level (prior conditions).
- Vehicle in horizontal position.
- Check gearbox is not in back-up mode.
- Remove the oil filler cap (3).
- Add 0,5 litres extra oil into the gearbox.
- Foot on the brake, change through all the gears.
- Selection lever in position "P".
- Engine running, at idle.
- Oil temperature: 60°C (+8°C ; -2°C), measured by means of the diagnostic tool.
- Remove the oil level plug (2).
Thread of oil then "drip-drip".
Refit the plug (3) (equipped with a new seal). Tighten to 2,4 m.daN.
"Drip-drip" or nothing.
Refit the oil level plug (2).
- Stop the engine.
- Add 0,5 litres extra oil into the gearbox.
- Repeat the oil level procedure.
NOTE: The level is correct at the moment the thread of oil becomes “drip-drip”.
- Refit the oil level plug (2) (equipped with a new seal), tighten to 3,3 ± 0,5 m.daN.
- Refit the oil filler plug (3) (equipped with a new seal), tighten to 2,4 m.daN.
NOTE: Dimension X = 48 mm.
An excessive level of oil can lead to the following
consequences:
- Oil heating up abnormally.
- Oil leaks.
A level that is too low will result in the destruction of the
gearbox.
To Next Page
Loading...
Need help?
General
