375
BRAKES
BLEEDING AND FILLING THE BRAKING SYSTEM
Bleeding the braking circuit without the bleed apparatus.
NOTE: Two operators are necessary.
For each brake circuit:
- Apply the brake pedal to place the circuit under pressure.
- Couple a transparent tube on the bleed screw.
- Submerge the other end of the tube in a clean container.
- Open the bleed screw.
- Wait until the fluid flows out without air bubbles.
- Close the bleed screw.
NOTE: Recommence the process a second time if that is necessary.
Check the level of the brake fluid (between the «DANGER» level and
the «MAXI» level).
Fill if necessary with the the approved and recommended synthetic
brake fluid.
Bleeding the secondary braking circuit.
WARNING: During the bleed operations: take care to maintain the level
of the brake fluid in the reservoir, keep it topped up.
NOTE: The bleed apparatus [1] is still connected on the brake fluid
reservoir (4).
Use the diagnostic tools [2] or [3].
Select the menu corresponding to the vehicle:
- ABS menu (according to equipment).
- ESP menu (according to equipment).
Follow the instructions of the diagnostic tool.
At the end of the bleed programme, check the level of the brake fluid,
top up if necessary.
Check the travel of the brake pedal: it must not be excessive. If it is,
restart the bleed procedure.
To Next Page
Loading...
Need help?
General
