ID-FLX Lite & Telecom Global Guide
189
Related FW 2.5.0 Related applications
Comm object 304
Description
Input works in MAN mode only switching between running states Nominal/Idle. Active Nominal/Idle input
activates binary output Idle/Nominal and sends Speed request = Idle speed (page 115) and/or active
(binary) IDLE command to the ECU (e.g. to Volvo EMS).
Eng state Sped request in MAN mode Sped request in AUT mode
Idle Idle speed (page 115) Idle speed (page 115)
Running ECU SpeedAdj (page 120)
… anything within
MinSpeedLim (page 121)
MaxSpeedLim (page 121)
Active input opens the READY TO LOAD (PAGE 201) during the engine running state. Ready to Load can be
closed back (if other conditions are fulfilled – see the READY TO LOAD (PAGE 201) description) if
Nominal/Idle is opened.
Nominal/Idle
6 back to List of LBI
Related FW 2.5.0 Related applications
Comm object 165
Description
If the input is active, the Speed Request may increase the engine speed value. The Speed Request value
may also depend on the conditions which are described in the chapter below.
Note: See Speed request chart (page 61).
Speed Up
6 back to List of LBI
Related FW 2.5.0 Related applications
Comm object 164
Description
If the input is active, the Speed Request may decrease the engine speed value. The Speed Request value
may also depend on the conditions which are described in the chapter below.
Note: Speed Up/Down binary inputs are active only when LAI SpdRequest (page 126) = OFF.
Note: See Speed request chart (page 61).
Speed Down
6 back to List of LBI
To Next Page
Loading...
Need help?
General
