D-Link DGS-3100 SERIES User Manual

DGS-3100 Series Gigabit Stackable Managed Switch User Manual
168
Configuring Local Enable Password
The Configure Local Enable Password Page allows network administrators to configure the local enabled password. To
define the network Local Enable password:
1. Click Security > Access Authentication Control > Configure Local Enable Password. The Configure Local
Enabl
e Password Page opens:
Figure 5-15 Configure Local Enable Password Page
The Configure Local Enable Password Page contains the following fields:
Field Description
Old Local Enable Password
Provide the current network Enable password.
New Local Enable Password
Defines the new network Enable password. The field range is 1-15 characters.
Confirm Local Enable Password
Confirms the new network Enable password.
2. Enter the old local enable password In the Old Local Enable Password field.
3. Define the new local enable password in the New Local Enable Password field.
4. Re-enter the new password in the Confirm Local Enable Password field.
5. The new local enable password is configured, and the device is updated.

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C