DGS-3100 Series Gigabit Stackable Managed Switch User Manual
235
B
SYSLOG ERRORS
The Syslog Error Message Table displays a list of Syslog error messages appearing on the Switch according to level of
severity and category, while providing a description for each error. There are seven levels of severity which are based on a
hierarchy of severities. “Emergency” is the highest and “Debug” is the lowest. The user can only configure “All”,
“Informational” and “Warning”. When a user configures a specific level, it applies to the configured level and all the levels
above. For example, if a user defines an “Information” error message, it will apply to all messages from the “Informational”
severity level up to the “Critical” level.
The seven severity levels are:
1. Critical
2. Warning
3. Error
4. Alert
5. Notice
6. Informational
7. Debug
All – Represents Debug and above.
The following table displays the Syslog Error Messages:
Table 4: Syslog Error Message Table
ID SEVERITY CATEGORY MESSAGE DESCRIPTION
SYSLG6.4.0 Critical %(1)s
SYSLG8.16.10 Critical No memory 1
SYSLG8.16.11 Critical No memory 2
SYSLG8.16.16 Critical web
No free connection at the
moment - wait one minute
and retry.
Currently there is no free
connection available. Wait
one minute and retry.
SYSLG8.16.17 Critical System No free memory No free memory available.
SYSLG8.16.18 Critical System No free UDP port
The system must be
restarted.
SYSLG8.16.29 Critical System
Cannot create private
memory pool
Cannot create a private
memory pool.
SYSLG8.16.31 Critical AAA Session amount exceeded Session amount exceeded.
SYSLG8.16.6 Critical Up/Download Illegal file type Illegal file type.
SYSLG8.16.9 Critical Up/Download Duplication of file name A file name is duplicated.
SYSLG8.47.35 Critical IP
Select master IP failed on
ifIndex %(1)j@
Selected master IP failed on
the specified ifIndex.
SYSLG8.47.37 Critical IP
Primary IP address could
not be obtained@
Primary IP address could
not be obtained.
SYSLG8.47.8 Critical Table is empty@ The table is empty.
SYSLG8.49.22 Critical
sshTlp_packet_read_pack
et: Padding error - need
%(1)d block %(2)d mod
%(3)d
SYSLG8.49.24 Critical SSH
sshTlp_kex_setup: Insufficient memory