To Next Page

To Previous Page

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 21

Powering On the Printer

1. Pre ssthepowerswitch.

2. Makesurethattheprinterpowersonandbeginsinitializing.

TheLCDpaneldisplaysInitializingwhiletheprinterchecksand

positionstheinkribbonandretransferfilm.

Duringpoweron,theprinter’sLCDpaneldisplaysthefollowing

statusmessages:

 Whenoperationchecksarecomplete,Preheatingis

displayedontheLCDpanelforapproximatelytwominutes

whiletheretransferroller(andoptionalbendremedy

roller)warmtotheiroperatingtemperatures.

 Whenreadytoprint,theLCDpaneldisplaysReady.

3. Thefirsttimeyouprintcards,initializetheinkribbonandretransferfilm.Referto“Initializing

theInkRibbonandRetransferFilm”onpage 22.

Theprintercanrequiresever alminutesbetweenpoweronandtheReadystatus.

PowerSwitch

DataCard SR200 User Manual

Other manuals for DataCard SR200