DigiTech DigiGate-700 User Manual

3 - 54 Operating Instructions
DigiGate-700
for Windows
™ ®
Figure 3-112
Figure 3-113
Clear Areas
1. From the Utility Menu with the System
Controller tab active, Click on the Clear
Areas button. Figure 3-112.
NOTE: This routine clears all of the tenants
from the control area you select. This will
remove any tenants that the System Controller
lists as onsite. It will also clear the Graphics
screen of blinking on site tenants if you have the
DigiGraphics option. Also, if you have had
your installer set the AntiPassBack option
to Hard, any tenants in the area cleared WILL
NOT be able to use the keypads to open the exit
gate.
2. This will open the Clear Control Areas
window. Figure 3-113.
3. All control areas defined in your system setup,
will be listed in the white data area on the
screen. Select (Check) or Deselect (Uncheck)
these control areas as needed.
NOTE: The All and None buttons on this
screen will Select or Deselect all control areas
respectively.
4. Click on the OK button to clear the area or on
the Cancel button to abandon the operation.
5. When the operation has been completed, you
will return to the Utility Menu .

DigiTech DigiGate-700 Specifications

General

Brand	DigiTech
Model	DigiGate-700
Category	Other
Language	English