DigiTech DigiGate-700 User Manual

2 - 11DigiGate-700
™
for Windows
®
- User’s Guide
DigiGate-700
for Windows
™ ®
1. From the System Setup tab of the Setup
Menu , Figure 2-9, Page 2-5, Click on the
Required Fields button.
2. This will open the Required Fields window.
Figure 2-20.
3. The window opens with the Tenant Informa-
tion tab active. The Last Name field is the
only listed field that is required for DigiGate-
700 for Windows, all others are optional for
your use. These check boxes are toggles, which
means that the state changes every time you
click on one of them. If it is checked when you
click on it, the box becomes unchecked, and
vice versa. A check in the box means that the
field is required, no check means that it is not
required.
4. Select the fields you want to make mandatory
when you enter tenant information.
5. When all Tenant Information fields have
been set as you want them, Click on the Unit
Information tab.
6. This opens the Unit Information window
which shows the fields you can require when
you enter unit information. Figure 2-21.
7. Select the fields you want to make mandatory
when you enter unit information.
NOTE: Be careful before you Select the Mux
Number and Slot Number fields. These
fields are ONLY for units that have individual
door alarms. If EVERY door at your location
has an individual door alarm, then you may
check these two as required fields. If all doors
are not alarmed, DO NOT Select these two
fields.
8. When all Unit Information fields have been
set as you want them, Click on the OK button
to accept the choices, or on the Cancel button
to discard selections and return to the Setup
Menu .
Figure 2-20 Figure 2-21
Required Fields

DigiTech DigiGate-700 Specifications

General

Brand	DigiTech
Model	DigiGate-700
Category	Other
Language	English