DigiTech DigiGate-700 User Manual

2 - 16 Setting Up a New Site
DigiGate-700
for Windows
™ ®
Figure 2-30
Figure 2-31
4. The Modify Site screen opens with the Site
Name tab active. This screen holds the Site
Number, Site Name, and Address information.
Figure 2-30.
5. Enter the information requested and click on the
Other Info tab.
6. This screen holds the phone number to the
modem at the site, if this is a remote site, and
the location of the Unit and Tenant data files for
this site. Figure 2-31.
7. For a remote site, enter the telephone number of
the modem at the remote site in the Modem
Number field. If this is a headquarters or local
site, leave this field blank.
8. The Data Path field will hold the location of
the Unit and Tenant files for this site. The data
path was set up before shipping your software
and has been created on your PC during
installation of the program. DO NOT
CHANGE THIS INFORMATION UNLESS
DIRECTED TO DO SO!
9. Click on the OK button to accept the changes or
on the Cancel button to abandon the change
and return to the Define Sites selection screen.
NOTE: Repeat steps 3 - 9 for each site listed
on the Define Sites selection screen.
Figure 2-29, Page 2-15.

DigiTech DigiGate-700 Specifications

General

Brand	DigiTech
Model	DigiGate-700
Category	Other
Language	English