Loop
The Loop key activates the Loop mode.
The loaded media will be played according to the Loop mode selected in the Configuration tool:
continuous Loop (clip or playlist) or Bounce (clip).
Browse
If the Browse function is activated after a search by TChas been done on clips or trains, you can use the
jog to browse between the different results found.
See section "Searching for Clips or Trains by Timecode" on page 85.
If the Browse function is activated when a mark point exists for the current picture, the jog dial allows
you to jump from one mark point to another.
See sections "Managing Mark Points on Trains" on page 57 and "Managing Mark Points on Clips" on
page 105.
IN
The IN function defines the IN point of a clip.
The key will light differently depending on the situation:
Key color Meaning
Red key The key lights red if the on-air image is at this IN point.
Green key The key lights green
• when a train is loaded, if an IN point exists but is not the image you see.
• when a clip is loaded, if the current TC > INpoint.
White key • When a train is loaded and no INpoint has been marked.
• When a clip is loaded and the current TC < IN point.
See section "Creating Clips" on page 78.
Goto IN
When you are in a record train, the Goto IN function allows you to go back to the IN point, if any has been
defined.
When you are in a clip, this function allows you go back to the IN point of the clip. See section "Browsing
and Playing Clips" on page 123.
When you are in a playlist, this function allows you go back to the IN point of the current playlist element.
See section "Browsing a Playlist" on page 222.
USER MANUAL
LSM-VIA |4. Commands on the Remote Panel| 35
To Next Page
Loading...
Need help?
General
