◦ click the position in the Clip grid:
5. Paste the clip (Clip view) or the cam angle of the clip (CAMview).
◦ to paste it with its guardbands (Long copy), press + + .
◦ to paste it without its guardbands (Short copy), press + .
The selected clip (Clip view) or CAMangle (CAMview) is copied, or moved, to the selected position.
Pref Cams remain the same when they are copied or moved.
If only the secondary CAMis copied, it becomes the principal pref cam, and the next smallest cam
becomes the secondary pref cam.
6.3.7.ManagingMarkPointsonClips
Context of Use
Mark points are used as tags to mark points on the record trains and clips during recording or playback.
Once this marking is done, you can use the mark points to quickly and easily retrieve those specific
moments and use them.
Up to 999 mark points can be set. They are linked to the workstation and they are lost after LSM-VIA
reboot.
Default Values
• Default Mark Points:
Depending on the Default Mark Points setting, mark points can be added at the LIVEinput timecode
(Live mode) or at the current timecode of the clip or the train (Playback mode). By default, the Live
mode is set. This can be changed from the LSM-VIA configuration tool.
• Freeze on Marks:
This parameter specifies whether Multicam will freeze or not when it reaches a mark point set on the
clip and/or the record train that is being played back.
By default, the playout does not freeze on the mark points when clips or record trains are being
played. This can be changed from the LSM-VIA configuration tool.
Mark Point Display
When at least one mark point has been set on the controlled media, the key button on the Remote lights
up.
• When the current timecode is not on a mark point timecode, the key button is green.
USER MANUAL
LSM-VIA |6. Working with Clips| 105
To Next Page
Loading...
Need help?
General
