Preferred Camera Angles
The clips are created with the following preferred cameras depending on the cameras loaded on the
play channels when the clip is created:
Channel Control
Mode
Controlled
Channel
1st Preferred CAM (*) 2nd Preferred CAM (=)
PGM+PRV PGM+PRV CAM angle loaded on PGM CAM angle loaded on PRV
PGM+PRV PGM CAM angle loaded on PGM Lowest alphabetical CAM angle
available
PGM+PRV PRV CAM angle loaded on PRV Lowest alphabetical CAM angle
available
Multi-PGM All PGMs CAM angle loaded on PGM1 CAM angle loaded on PGM2
Multi-PGM Single PGM CAM angle loaded on
controlled PGM
Lowest alphabetical CAM angle
available
OSD Display
When you have set an IN point:
• IN is displayed on the OSD when you are after the IN point.
• - IN is displayed on the OSD when you are before the IN point.
When you have set an OUT point:
• OUT is displayed on the OSD when you are before the OUT point.
• + OUT is displayed on the OSD when you are after the OUT point.
How to Create a Clip from the Remote Panel
Whatever the channel control mode, you create a clip on the controlled camera angles and on all the
camera angles defined in the Automake setting.
You create a clip by defining only an IN or an OUT point if it is based on a default clip duration.
Otherwise, you need to define both IN and OUT points. The clip is always created with the same IN and
OUT points on all clip angles.
You can create a clip locally from a local or a remote train.
When the record trains are loaded on the play channels, create a clip as follows:
1. In the record train, jog to the requested position for IN.
USER MANUAL
LSM-VIA |6. Working with Clips| 79
To Next Page
Loading...
Need help?
General
